KwikTic Industry 4.0 MES Manufacturing and Shopfloor Data Collection software. Quality, Productivity and Traceability Software

Keep It Simple

Chart Reports

Bar, Stacked, Line and Pie Charts are some of the most best understood Graphical methods for representing data. KwikTic has a full set of generic reporting tools which deal with the most commonly asked questions and give flexibility to dig deeper into more specific detail when required.

Below are some examples: 

Defect Reporting (also see Data Reports and Measels)

FailureModes broken down by Part No. Donut of most common Failures Simple Pareato of Failuremodes
Gauge - Defects recorded in timescale Failure Rate based on acctual parts usage Most Problematic Shopfloor Areas
Production Reports    
WIP Report - # Passed through Line Section WIP Report - Last seen & Status (Good / Bad) 1st Pass